Redpine Signals, Inc.
Page 41
R
R
S
S
-
-
W
W
C
C
-
-
3
3
0
0
1
1
E
E
v
v
a
a
l
l
u
u
a
a
t
t
i
i
o
o
n
n
B
B
o
o
a
a
r
r
d
d
U
U
s
s
e
e
r
r
G
G
u
u
i
i
d
d
e
e
V
V
e
e
r
r
s
s
i
i
o
o
n
n
2
2
.
.
5
5
1
1
Figure 11: Messages in Hyper-terminal
8.
If the module has NOT become a GO (Group Owner), issue the below
command to get an IP address from the phone. If the module has
become a GO, this command need not be issued.
at+rsi_ipconf=1,0,0,0
The acquired IP address is returned to the Host and can be observed
in Serial Port Monitor.
Please refer to the description for the command
Join
in the
Programming Reference Manual. The parameter
GO_Status
returned
with the OK response of the
Join
command is used to determine
whether the module became a GO or not. If the module becomes the
GO, it will internally assign itself the IP
192.168.100.76
and will act
as a DHCP server. The Wi-Fi Direct phone will acquire an IP address
from the module automatically (assuming DHCP client is enabled in
the phone). Since the
Group_Owner_Intent
in point #5 above has
been set to the highest value, there is a very strong chance the
module will become a Group Owner.
Issue “Connect” on the
Phone also when the
“Join” command is issued
in the module.
Module reported the
device name of the
Phone
