Redline Communications AN-50e, Руководство пользователя

Страница: 97 / 100

AN-50e
user manual
70-00033-01-03 Proprietary Redline Communications © 2005 September 2005
Page 97 of 100
6.6.1 Pass-Through Configuration
This procedure is to aid configuring point-to-multipoint (PMP) operation on AN-50 and AN-
50e systems. For complete installation and operational procedures. refer to the
AN-50e
System User Manual , the AN-30e/AN-50e Quick Install Guide, and the Redline BFW
Installation Guidelines provided on CD-ROM.
The VLAN tagging feature allows the user to configure and operate an AN-50e
deployment as a VLAN-aware wireless switch. A 'group' is created at the sector controller
for each VLAN to be transported, and 'connections' are added to enable data flow with
any subscriber station participating in that VLAN. If VLAN is not required, a default group
and set of connections must be setup to define the traffic characteristics. Prior to
completing this setup, no Ethernet data traffic can be transmitted over the wireless
interface.
The procedures provided below include steps to setup a basic working configuration for
initial testing, and then to introduce VLAN traffic controls.
6.6.2 Configure Pass-Through Operation
For initial installation and testing, it is recommended to setup a PMP configuration without
VLAN support. Use the following steps to configure a PMP pass-through link.
# Action Description
A Create a
new Link
for each
subscriber
station.
1.
Click New Link to display the Link Configuration screen.
2.
Enter a unique name for this link in the Link Name field.
3.
Enter the MAC address of the subscriber station in the Peer MAC
field.
4.
Select the MAX DL Burst Rate and MAX UL Burst Rate for this link
(based on link budget calculations).
5.
Use the default values for all other fields.
6.
Click the Apply button to save and activate these settings.
7.
Repeat steps 1 - 6 for each subscriber station.
B Create a
single
Pass-
through
Group at
the sector
controller.
1.
Click New Group to display the Group Configuration screen.
2.
Enter a unique name for this group in the Group Name field.
3.
Set the Group Tagging Mode to Pass-through.
4.
Check the SC Ethernet Enable box .
5.
Set the Group QoS value for sending multicasts (i.e., 5).
6.
Use the default values for all other fields.
7.
Click the Apply button to save and activate these settings.
C Create
connection
s joining
each
subscriber
station to
the sector
controller
pass-
through
group.
1.
Click New Connection to display the Connection Configuration
screen.
2.
Enter a unique name for this connection in the Connection Name
field.
3.
Set the Connection Tagging Mode field to Pass-through.
4.
Enter the Link ID of a subscriber station in the Link ID field.
5.
Enter the Group ID in the Group ID field.
6.
Set the DL QoS Level and UL QoS Levels. Default values are MAX
Burst Rate Value - 1.
7.
Click the Apply button to save these connection settings.
8.
Repeat steps 1 - 7 to add a connection for each subscriber station.