Redline Communications AN-50e, Руководство пользователя

Страница: 66 / 100

AN-50e
user manual
70-00033-01-03 Proprietary Redline Communications © 2005 September 2005
Page 66 of 100
4.6 Operating Notes
4.6.1 Setting Up for Pass-Through
Prior to software version 3.XX, it was only necessary to configure the Link ID
parameters before data traffic could be transmitted across the wireless interface. In
V3.0, at east one group must be configured, and then a connection for each
subscriber station before you can transmit data traffic between the sector controller
and the subscriber stations.
Figure 29
:
Op. Notes - Basic Pass-through Group Configuration
The following table provides a summary of the configuration shown in the pass-
through configuration diagram above. The actual group and link ID values are not
available until these items have been created during configuration of the system.
This configuration passes all data traffic as a standard PMP configuration.
Table 21
:
Op. Notes - Basic Pass-Through Group Settings
Group Configuration
(sector controller)
Connection Configuration
(Subscriber station)
Group
Name
Port
Tagging
Group
VID
Connection
Name
Port
Tagging
Link
ID
Group
ID
Connection
VID
SC-1 Pass
Through
NA SS-1 Pass
Through
[L-1] [SC-1] NA
SS-2 Pass
Through
[L-2] [SC-1] NA
Note: The Group ID, Conn ID, and Link ID values are assigned
automatically and must be read from the screen after items are created.
To provide basic PMP connectivity without VLAN support, a single pass-through
group must be configured on the sector controller, and each subscriber station must
have a connection configured for pass-through. The only operating restriction is
that the default priority field is used to set the packet priority of each packet
forwarded to the Ethernet port on the sector controller and subscriber stations.
Use the following steps to create a simple pass-through configuration suitable for
initial system testing of a version 3.x system.