The DGL1010VS can be used on its side for vertical alignment or together
with the dot laser out of the front to produce a 90 degree square for site
layout. The DGL1010VS can be placed on its side either directly on a tripod
or on its included side plate with the datum marker and roughly levelled
using the adjustment feet and bubble vial, this brings the laser into self
levelling range where the electronics take over. Press On/Off button to
self level.
Note in vertical rotation mode features such as “TILT”, “V-W-S” and “Scan”
can still be used the same as when in normal horizontal rotation mode.
Once levelled and rotating you can electronically aim the dot laser to a target
left to right by pressing and holding the grade/slope arrow button the
longer you hold the faster the dot moves. This is useful for site layout
squaring;
•
Place datum marker over the datum point marking the conjunction of
the 90 degree lines.
•
Roughly align laser housing so dot is striking target point along the one
line of the 90 degrees, then use the direction buttons to electronically
fine tune this alignment.
•
Once the dot is on the target use the receiver to pick up the rotating line
on the second line of the 90 degree. Your square is now set.
11
Vertical Rotation Operation
(refer to diagram page 4)
Содержание DGL1010VS
Страница 1: ......
