RED DSMC OPERATION GUIDE: WEAPON/SCARLET-W
COPYRIGHT © 2016 RED.COM, INC
955-0116_V6.1, REV-U | 189
LENSES
This section describes lenses and lens operations for the camera system.
WARNING:
All lenses are hot swappable. However, lens mounts are NOT HOT SWAPPABLE, meaning you cannot
remove or install lens mounts while the camera is turned on. Before installing or removing lens mounts, you
MUST turn off the camera. Failure to do so may result in damage to the lens mounts or camera that is not
covered under warranty.
LENS WEIGHT AND LENS SUPPORT
Use a lens support system when mounting heavy or long lenses to your camera.
When mounting a heavy or long lens, ensure that the full weight of the lens is never directly on the camera or
lens mount. Mount the lens to the support system first, and then carefully mount the lens to the camera.
Due to the lightweight construction of the carbon fiber BRAIN and magnesium mounts, most setups with the
carbon fiber BRAIN require a lens support system for all but the lightest lenses.
WARNING:
Failure to use lens supports appropriate for the lens and camera setup may lead to damage of the
camera and lens mount. Any damage caused by not using a lens support system will not be covered under
warranty.
POSITIVE LOCK (PL) LENSES
This section describes the appropriate method for attaching and detaching PL lenses. For more information,
refer to the original manufacturer’s instructions. This section also lists lenses supported by the camera PL
mounts.
WARNING:
ALWAYS protect your equipment, when it is not in use, by replacing lens caps and mount caps.
ATTACH PL LENSES
1. Rotate the locking ring counter-clockwise to release the camera mount cap.
2. Remove the rear lens cap and the camera mount cap.
3. Align the key and contact pads (if present) on the PL lens with the key and connector pins on the camera
PL mount.
4. Insert the lens into the camera PL mount.
5. Rotate the locking ring clockwise to secure the lens in place.
DETACH PL LENSES
1. Rotate the locking ring counter-clockwise to release the PL lens.
2. Remove the PL lens from the camera PL mount.
3. Replace the rear lens cap and camera mount cap when the lens is not in use.
Содержание SCARLET-W Series
