COPYRIGHT © 2016 RED.COM, INC
RED DSMC OPERATION GUIDE: WEAPON/SCARLET-W
955-0116_V6.1, REV-U | 190
CAMERA PL MOUNT SUPPORTED LENSES
The DSMC Mg PL Mount 2.0, DSMC TI PL Mount, and the RED MOTION MOUNT Ti PL are compatible with
most standard PL mount cinema lenses and devices. For information about the compatibility of the RED
MOTION MOUNT Ti PL, see the
at
WARNING:
Using a non-standard PL mount lens or device with a camera PL mount may damage the camera and
lens mount. Any damage caused by not using a standard PL mount lens or device will not be covered under
warranty.
FUJINON T2.9 CABRIO PREMIER PL LENSES
NOTE:
The VTR switch on the lens is mapped to Record: Toggle by default. The VTR switch can be mapped to
another key.
The following Fujinon
®
T2.9 Cabrio Premier PL lenses are compatible with all camera PL mounts, but must be
powered externally and configured a specific way:
Fujinon 14-35mm T2.9 Cabrio Premier PL
Fujinon 19-90mm T2.9 Cabrio Premier PL
To set up the Fujinon T2.9 Cabrio Premier PL lenses, follow the instructions below. Refer to the manufacturer’s
operation manual for detailed information about setting up and using the lens.
1. Attach the lens to the camera PL mount.
2. On the lens, set the
Camera Communication
switch to
On
.
3. On the lens, set the
LDS, /i Select
switch to
Off
.
4. Connect an external power source to the lens.
5. Go to
Menu
>
Settings
>
Setup
>
Lens
.
6. Deselect the
Enable Power to Lens
check box.
NOTE:
This option is only available when a camera PL mount is attached to the camera.
7. The lens should be successfully connected. However, if lens data does not display within 10 seconds, go
to
Menu
>
Settings
>
Setup
>
Lens
and select
Detect Lens
.
CANON EF LENSES
This section describes the appropriate method for attaching and detaching Canon
®
EF lenses. For more
information, refer to the original manufacturer’s instructions. This section also lists lenses supported by the
DSMC Canon EF Mount.
WARNING:
ALWAYS protect your equipment, when it is not in use, by replacing lens caps and mount caps.
ATTACH CANON EF LENSES
1. Rotate the secondary locking ring counter-clockwise to disengage.
2. Press the lens release button and rotate the lens cap counter-clockwise to remove the camera mount cap.
3. Remove the rear lens cap.
4. Align the red dot on the lens with the red dot on the DSMC Canon Mount and position the lens in the mount.
5. Turn the lens clockwise until it clicks into place.
6. Rotate the secondary locking ring clockwise to engage.
DETACH CANON EF LENSES
1. Rotate the secondary locking ring counter-clockwise to disengage.
2. Press and hold the lens release button. While holding the lens release button, turn the lens counterclockwise
until it stops and remove it from the camera mount.
3. Replace the rear lens cap and camera mount cap when the lens is not in use.
Содержание SCARLET-W Series
