RED Dalia Oyster, Руководство по эксплуатации и обслуживанию

Страница: 41 / 44

PELLET STOVES Chapter 6
red
INSTALLATION AND USE MANUAL
page
41
Problems/Causes/Solutions Technical service - Rights reserved - Reproduction prohibited
PROBLEM
LED
POSSIBLE CAUSES Solutions:
The stove is
signalling pellet
hopper temperature
over the safety limit
Led 0.
 Pellet load too high
 Room fan power too low
 The door is not closed properly or the seals
are worn.
 Combustion chamber dirty
 Outlet obstructed
 Pressure switch faulty or broken
 Structure has overheated due to
reduced heat dissipation.
 Room fan faulty
 Wait for the stove to cool,
re-ignite it and decrease the
pellet load following the
instructions in section 4.10
 Wait for the stove to cool,
re-ignite it and increase the
fan using knob A
 Close the door or have the
seals replaced with original
spares
 Clean the combustion
chamber according to the
instructions in the manual
 Clean the smoke duct
 Replace the pressure switch
 Verify the correct
positioning of the stove
 Increase the smoke fan
speed according to the
technical manual
 Replace the room fan
The stove signals
anomalous
operation of the
smoke fan
Led +1
 Impediment in fan rotation
 Smoke fan faulty
 Check the reason for the
impediment
 Replace the faulty
component
The stove signals
smoke temperature
too high or smoke
probe faulty
Led +2
 Pellet load too high
 Unsuitable pellets.
 Room fan power too low
 Structure has overheated due to
reduced heat dissipation.
 Room fan faulty

Smoke probe faulty
 Smoke outlet blocked
 Increase the pellet load
following the instructions in
section 4.10
 Remove the unsuitable
pellet from the hopper and
exchange it with one
recommended by the
manufacturer
 Increase the fan speed
using knob A
 Verify the correct
positioning of the stove
 Replace the faulty
component
 Clean the smoke outlet
The stove signals
that the door is
open
LED -2
LED -1
 The door was not shut properly  Make sure it is shut
The stove signals
the pressure switch
LED -1
LED 0
 Draught problem
 Clogged brazier
 Check or if necessary clean
the brazier and flue pipe of
any incrustations
 Check whether the brazier is
in place
Pellet hopper door
open
LED 0
LED +1
 The door is not shut properly due to an
excess pellet load in the hopper
 A few pellets are not in place
 Reduce the pellet level in
the hopper.
 Check whether anything is
preventing the door from
being shut properly