RED Dalia Oyster, Руководство по эксплуатации и обслуживанию

Страница: 26 / 44

PELLET STOVES Chapter 4
red
INSTALLATION AND USE MANUAL
page
26
Operation Technical service - Rights reserved - Reproduction prohibited
4.5.
STOVE POWER SUPPLY
Once the power cord is connected to the rear part of the stove, place
the switch, also on the rear, to position (I).
The lighted button of the switch will come on.
The switch located to the rear of the stove powers the system.
On the rear of the stove there is a fuse box which is located
underneath the mains socket. Use a screwdriver to open the fuse box
if necessary replace them (3.15 A delayed).
4.6.
FIRST LIGHTING
4.6.1.
Ignition/shutdown using the control panel
(Key D)
The stove is ignited and shutdown by pressing key D on the control
panel for 2 seconds.
When switching on, LED 1 flashes green, whereas when the stove is lit
it is fixed green.
After a start-up phase lasting about 20 minutes, the stove
enters into full working order (led 1 lit with fixed green light).
Key D is also used to switch the stove off (see section.4.8).
4.7.
OPERATING MODE
4.7.1.
Setting room temperature (Knob B)
By using command B it is possible to set the desired temperature for
the room in which the stove is installed from a minimum of 15°C to a
maximum of 30°C.
When such condition is obtained the stove goes into a status
corresponding to the minim values of consumption (flam and hot air fan
speed at minimum, see following points), to then return to the set
values when the room temperature drops below the set threshold.
4.7.2.
Setting the flame power (Knob C)
Using command C the flame power is set from a minimum of 1 to a
maximum of 5.
The levels of power correspond to a different fuel consumption value:
by setting 5 the room will be heated in less time, setting 1 the room
temperature will be maintained for a longer period of time.
The flame power setting is only effective after
ignition and therefore in full working order.