RED Dalia Oyster, Руководство по эксплуатации и обслуживанию

Страница: 27 / 44

PELLET STOVES Chapter 4
red
INSTALLATION AND USE MANUAL
page
27
Operation Technical service - Rights reserved - Reproduction prohibited
4.7.3.
Setting the hot air fan speed (Knob A)
Using command A the hot air fan speed can be regulated.
The fan starts to work when the stove has reached a
default (factory setting) temperature value.
During the switch off process, the fan stays on until
the stove has cooled down.
4.7.4.
Note on first ignition
The first attempt at ignition may not be successful,
since the feeder screw is empty and it is not always
able to fill the grate with required amount of pellets
in time to ensure normal ignition
CANCEL THE CONDITION OF ALARM FOR FAILED
IGNITION BY PRESSING KEY D FOR A FEW SECONDS
(see section 4.17). REMOVE THE PELLET LEFT IN THE
BURNER AND REPEAT IGNITION
After repeated attempts at lighting, if there is no flame even though
pellets are flowing normally, check that the grate is correctly
positioned. It must be placed where it adheres perfectly to its
housing and free of any ash incrustations . If after this check no
abnormalities are found, it means that there may be a problem with the
stove components or that installation may not have been carried out
correctly.
REMOVE THE PELLETS FROM THE BURNER AND
CONTACT AN AUTHORISED TECHNICIAN.
4.8.
SHUTDOWN MODE (Key D)
The stove is shutdown by pressing key D . From this moment a
completely automatic cooling phase begins which includes the
interruption of loading the fuel, cleaning the grate and the smoke
discharge conduit.
Such phase may last for a variable time according to how many hours
the stove has been lit and its position; the smoke blower fan will
revolve until the minimum default temperature (factory setting) is
reached.
NEVER SHUTDOWN THE STOVE BY CUTTING OFF THE
MAINS.
Always leave it to complete the shutdown cycle,
otherwise damage could be caused to the structure,
and also problems with ignition in the future.