OPERATION
AUTOPILOT
NautoPilot 5000 Series
67
4002.DOC010102
Edition: September 2014
Table 9
Softkeys for ”Acceleration Monitor” display
Function
Figure 33/1
Indication of max. speed (as calculated by the settings of accel-
eration limit, see next display “Setup Accel.Limit”).
Figure 33/2
Indication of max. RoT (as limited by the settings of accelera-
tion limit, see next display “Setup Accel.Limit”).
Figure 33/3
Indication of min. Radius (as calculated by the settings of ac-
celeration limit, see next display “Setup Accel.Limit”).
Figure 33/4
Indication of actual speed.
Figure 33/5
Check box of currently selected RoT--limit adjusted on Main
Page. Check box is active if RoT--limit is activated. (see initial
display Figure 22).
Figure 33/6
Check box of currently selected RAD--limit (Radius) adjusted
on Main Page. Check box is active if RAD--limit is activated.
(see initial display Figure 22).
Figure 33/7
Indication of actual acceleration limit.
Figure 33/8
Information on heading source and actual heading value.
Figure 33/9
Set heading value.
For Course Control this display is designated as “Presel.COG”
(Preselected Course Over Ground) after turning the rotary
knob, “Set COG” after releasing the knob (in increments of 1
degree or 1/10 degree -- depends on selected resolution).
For Track Control this display is designated as “Track Course”.
For Heading Control this display is designated as “Set Head-
ing”.
Figure 33/10 Touch--icon, toggles resolution for the respective value.
Figure 33/11 Numerical display for the ruder angle in degrees, the arrows
next to this display show the direction of the rudder angle.
Figure 33/12 Softkey for switching to ”Setup Accel. Limit” display.
Figure 33/13 Softkey for switching to the first display (main page).
Figure 33/14 Softkeys for changing the selected acceleration limit
parameters. Changes must be acknowledged with ”SET” (a
small icon is displayed after a change has been made see also
Figure 34).
Figure 33/15 Softkey for switching back to the previous display, without a
transfer of changed values.
Figure 33/16 Softkey for adjusting the threshold (in percent of adjusted
acceleration limit). An overshoot of this threshold leads to an
acoustic alarm at the Autopilot (only if the softkey ”Warning” is
set to ”on”).
Value range: 50% to 100%/ (in increments of 5%).
