OPERATION
NautoPilot 5000 Series
14
4002.DOC010102
Edition: September 2014
1.4
Basic operation modes
During any Autopilot control mode, switching over from one
connected sensor (for heading, position or speed) to another
sensor should not be performed.
However, if a switch over must be performed, it must be
verified that the difference in the sensor data is as small as
possible.
Please note:
Some basic operating modes differ in the type of
application, either standalone application or AS application.
1.4.1
Explanation of used symbols
Some symbols are used to explain these modes.
Below mentioned table shows their meaning.
Table 2
Used symbols
Symbol
Meaning
Key actuation
Set
LED flashing
Set
LED out
Set
LED alight
Acoustical signal on
Acoustical signal off
Go To Waypoint
Top bar of the display.
For colours and symbols,
see section 6 and , 6.1
for message texts, see
section 6.2.
