12.2 Testing
10A Screen
When the 10A range (or any other Range)
is selected, the following screen will appear
to allow the user to select the type of test
mode required:
Selection of “Single” starts a test sequence.
12.2.1 Single
The following screen will appear.
The system will conduct and run a single
test on a device. The test measurement
sequence completes within a few seconds.
The user has the option to:
•
“GO” : Start another test.
•
“Store” : allows to save a reading into a
Memory location (Archive).
•
“Print” : allows to go to the print screen.
•
“Mode” : Select another test mode.
•
“Setup” allows to go to the Range
Selection screen.
12.2.2 Cont (Continuous)
Cont starts a continuous test sequence.
In the continuous test mode, the test set
will measure until the user selects and
presses “Stop”.
The test system has an output of current
that runs continuously while the resistance
measurements are being taken.
90081-2.11 Micro Junior 2
Page 32 of 44
