Raymarine e7, Руководство по установке

Страница: 97 / 124

Problem Possible causes Possible solutions
Check that the controller and thermal camera are correctly connected to
the SeaTalk
hs network. (Note: This may be a direct connection or via a
SeaTalk hs switch.)
Check the status of the SeaTalk hs switch.
SeaTalk hs problem.
Check that SeaTalk hs cables are free from damage.
Control conflict, e.g. caused by multiple
users at different stations. Ensure that no other controllers are in use at the same time.
Check power / SeaTalk hs cabling to the controller and PoE injector (PoE only
used with optional Joystick Control Unit).
Erratic or unresponsive controls.
Problem with the controller.
Check other controllers if available. If other controllers are operating this will
eliminate the possibility of a more fundamental camera fault.
Camera is not a dual payload model. Only “dual payload” (dual lens) thermal cameras support VIS / IR switching. Cannot switch between thermal and
visible (VIS / IR) video image .
VIS / IR cable not connected. Ensure that the VIS / IR cable is connected from the camera to the
Raymarine system. (The IR-only cable does not support switching).
Poor quality or faulty video cable. Ensure that the video cable is no longer than necessary. The longer the
cable is (or the smaller the wire gauge / thickness), the more severe the
losses become. Use only high quality shielded cable suitable for a marine
environment. Noisy image.
Cable is picking up electromagnetic
interference (EMI) from another device. • Ensure you are using a high quality shielded cable.
• Ensure proper cable separation, for example do not run data and power
cables in close proximity with each other.
Troubleshooting
97