55M4500CCE00 REV A
2)
Press
“
”
, the display will change to show the current boom angle followed by a
target boom angle for calibration, normally 60°.
Adjust the boom angle to the target angle, when the boom is at the correct angle for
calibration the display will change to show:
3)
Press
“
”
, the display will change to show:
Carefully lift the test load just clear of the ground. Accurately measure the actual radius
of the suspended load from the centre line of slew of the machine.
4)
Use
“
”
or
“
”
to adjust the Corr.:
x.x
value until the displayed radius equals
the measured radius, note that the indicated radius can only be increased, not
decreased. Press
“
”
to accept the change, the system will confirm the
calibration is saved.
5)
Press
“
”
to return to the main calibration menu.
Carefully set the test load on the ground.
Содержание i4500
Страница 2: ...55M4500CCE00 REV A...
