RaycoWylie i4500, Инструкция по калибровке

Страница: 15 / 50

55M4500CCE00 REV A
Step #5: “Dimensions” Data entry
This menu contains crane dimensions that are necessary for the calculation of the load
on the hook, based on the hydraulic cylinder pressure. This data refers to the winch and
boom hoist cylinder geometry at the superstructure and some main boom dimensions.
Some or all of this information may be pre‐loaded prior to delivery but all dimensions
should be verified and edited as required before proceeding. Units in use will be feet or
metres depending on the setting made for ‘calibration units’ in step #3, a reminder is
shown on the bottom line of this display.
Remember to save any changes made.
Please advise Rayco Wylie of any changes required in this section.
Dimensions relating to boom tip attachments are stored in the chart file and are not
editable in this menu,
*see note 2 (page 17) .

CL1 (full retract): length of the main boom when fully retracted.


CL2 (full extend with extension): length of the boom with all sections fully extended
including any manual or power pinned extension if fitted.


CL2MR (full extend w/o extension): length of the boom fully extended but with any
manual or power pinned extension retracted. Note: For full power booms without a
manual section
CL2 and CL2MR are the same value.


CL3 (p2blh) – horizontal distance between the boom foot pin and lift cylinder base
pin.


CL4 (p2blv) – vertical distance between the boom foot pin and lift cylinder base pin.


CL7 (p2buh) – distance between the boom foot pin and lift cylinder top pin parallel to
boom telescoping centerline.


CL8 (p2cb) – vertical distance between the boom foot pin and the boom centerline
with the boom horizontal. Instead of using the boom centerline as a reference, It is
common to use the boom foot pin, in this case CL8 = 0 but ensure that CL9, CL10 and
CL11 all use the same reference.


CL9 (ra2cb) – vertical distance between the lift cylinder top pin and the boom
centerline (or boom foot pin, see CL8) with the boom horizontal. If the boom
centerline is higher than the lift cylinder top pin, then the distance is positive,
otherwise it is negative.


CL10 ‐ vertical distance between the lower boom tip sheave pin (hook suspension
sheave) and the boom centerline (or boom foot pin, see CL8) with the boom
horizontal.


CL11 ‐ vertical distance between the upper boom tip sheave pin and the boom
centerline (or boom foot pin, see CL8) with the boom horizontal.


CR1 ‐ lower boom tip sheave pitch radius (hook suspension sheave).


CF (slew offset) – horizontal distance between the boom foot pin and the centerline
of rotation of the machine. If the boom foot pin is behind the centerline of rotation
then the distance is negative, otherwise it is positive.


CH1 (height rubber)
–
vertical distance between the boom foot pin and the ground
when on tires.
