The universal bracket fits every bike we’ve run across so far. “Universal” means you
have to do a little work to fit your particular bike (Very little though. About 15 minutes
worth.) Here’s how.
Since the Brush Housing contains spring-loaded brushes, there needs to be a consistent
space between the housing and PUC. You can use one of the wire ties that came with the
kit as a gauge for this. You may also have to bend the mount to get the position right. The
following shows how to accomplish all this. (You may need 3 hands for this next part)
Place the mount in the gap (Yes…again) created at the very beginning of the install and
as usual, make sure it is completely seated against the axle. Now take a wire-tie and place
it with the thinnest side creating the gauge, against the PUC. Take the Brush Housing and
place the
brushes
against the PUC. The brushes will contact the ring first. Then compress
the housing towards the ring until it touches the wire tire.
Brush Housing Universal Mount Wire tie PUC
Содержание PowerPUC G4
Страница 13: ...New line showing misalignment...
Страница 17: ...Alignment check 12 o clock position Good...
Страница 18: ...Alignment check 9 o clock position Still good...
