Raw Desigh PowerPUC G4, Инструкционный лист

Страница: 5 / 26

Next, you’ll need to create a small gap between the wheel spacer and fork in order to
install the Universal Mount. To do this, loosen the axle bolts / clamps just a few turns.
Sometimes, the side you loosen will be where the gap naturally shows up. Other times it
will be the opposite side. Regardless, since we want the gap on the kickstand side of the
bike, you may have to lightly tap the axle with a rubber hammer or piece of wood to shift
the gap to that side. You can see the axle nut, axle clamp and small gap we created,
below.
Axle Nut Axle Clamp Gap
Different bikes have different axle sizes. Our Universal Mount should fit all known
applications.
The “U” portion is what will slip into the gap you just created and over the axle. Try it.
If the “U” is too small, you can remove the inner section by clipping the connectors at the
top of the “U” with a pair of snips. Then just move the inner piece back and forth and the
last connector at the bottom of the “U” will break off. It should now fit. Put it aside for
now.
Connectors