Preparation
u
Install the machine at the tractor:
u
Close the metering slide.
u
Set the mounting height:
u
u
Run the calibration test:
u
Set the spreading width limiter:
Spreading
u
Travel to the spreading location
u
Switch on the drive.
u
Open the metering slide and start spreading operations.
u
Finish spreading operations and close the metering slide.
u
Turn off the drive.
u
Discharge residual material:
Cleaning/maintenance
u
Open the metering slide.
u
Remove the machine from the tractor.
u
Clean and maintain the machine:
9.4
Setting the application rate
You can set the application rate via the metering slide opening at the numeric scale on the scale plate.
For this purpose, adjust the slide lever to the position determined according to the spreading material
chart or by means of a calibration test. This is the stop position to which you move the slide lever
mechanically prior to the spreading operation.
•
Adjusting it downwards, in the direction of higher values, opens the metering slide.
•
Adjusting it upwards, in the direction of lower values, closes the metering slide.
NOTICE!
Material damage caused by an insufficient metering slide opening
Insufficiently opened metering slides may lead to blocking and cause damage to the spreading
material. Increasing wear occurs at the agitator.
u
Select an adequately large opening for the metering slide at which the spreading material
can flow out unhindered.
9. Spreading operation
SA 121
5901026
55
Содержание SA 121
Страница 6: ...Table of contents 6 5901026 SA 121...
Страница 90: ......
