Rauch QUANTRON-K2, Инструкция по эксплуатации

Страница: 92 / 102

Alarm messages and possible causes 6
86
12 Flow factor is outside limits. Reference to the value range of the Flow
factor .

The entered value lies outside the
reference values.
13 Transmission fault. No
RS232 connection An error has occurred during data
transmission to the Control unit.
The data has not been transmitted.
14 Error at spreading width limit-
er The actuator cannot reach the target value
it is to be moved to.

Blockage

No position feedback
15 Memory full. Delete one pri-
vate fertiliser chart. A maximum of 30 spreading materials can
be saved.

No additional saving possible
17 Discs started up without
activation A speed pulse is applied although the
spreading disc drive has not been started,
i.e., the speed exceeds 20 rpm
18 Activate disc start. Confirm
with ENTER Before the PWM outlet is activated,
a confirmation prompt is displayed
19 Meter. slider ist closed.
Turn off agitator Metering slide closed. The speed sensor
reports a speed greater 20 1/min.
20 max. RPM reached!
Max. setting = 250 In the coarse salt, fine salt, damp salt, grit
and sand characteristic curves, a speed
greater than 250 min is supposed to be
reached.
21 Disc speed not reached. The hydraulic motor cannot reach the set
speed!

Not enough oil in the motor
22 Error at half-side slider The actuator cannot reach the target value
it is to be moved to.

Blockage

No position feedback
72 Error at SpreadLight The power supply is too high; the operat-
ing lights are switched off.
73 Error at SpreadLight Overload
74 Defect at SpreadLight Connection error

Defective cable

Loose plug connector
No. Message in display Meaning

Possible cause