Rauch QUANTRON-K2, Инструкция по эксплуатации

Страница: 53 / 102

Operation QUANTRON-K2
47
4
4.6.3 Special spreading (+%)
You can use the Special spr%) submenu to specify a percentage
quantity change for standard spreading.

The basis is the pre-set value of the spreading density.

100 % special spreading density corresponds to a doubling of the configured
spreading density.
Setting the quantity change:
1.
Call up the Machine settings > Special spreading (+%) submenu.
2. Enter the percentage by which you wish to increase the spreading quantity.
Entering values into the control unit is described in section
4.11.2: Input of
values using the cursor keys, page 65 .
3. Press the Enter key .
4.6.4 Levers (option)
In the Levers submenu you enter the actuator position at which the spreading
width limiter plates are installed.
NOTICE
During operation, you can change the percentage value of the spreading quan-
tity at any time using the
Special spreading key. The spreading volume can
only be increased and cannot be reduced .
NOTICE
The Levers submenu is active when only 1 actuator is connected.
NOTICE
The display shows the current position of the Spreading width limiter plates
based on the values in the
Lever submenu.
Setting Description
R The actuator installed at the right side of the Single-disc spread-
er controls the right side of the spreading width limiter plates.
L The actuator installed at the left side of the Single-disc spreader
controls the right side of the spreading width limiter plates.
R/L The actuator installed at the left or right side of the Single-disc
spreader controls the left and right sides of the spreading width
limiter plate
via a lever .