Machine settings
79
8
8.7
Full border or limited border spreading
Full border spreading is a boundary fertiliser distribution where fertiliser still lands
beyond the boundary, but there is just a slight underfertilisation at the field bound-
ary.
In limited border spreading, almost no fertiliser goes beyond the field boundary.
Underfertilisation at the field boundary must be accepted in this case.
The basic equipment of the machines makes only full border spreading possible.
For limited border spreading, you require the optional equipment GSE 7 or TELI-
MAT T1.
8.7.1
Full border spreading from the first tramline
Adjust the spreading vanes on the border side corresponding to the details
specified in the fertiliser chart.
Die metering slide setting corresponds to the metering slide setting on the field
side.
8.7.2
Limited or full border spreading with the limited border spreading unit GSE 7 (op-
tional equipment)
The limited border spreading unit limits the spreading width (either towards the
left or right) to a range between approx. 75 cm and 2 m from the centre of the
tractor to the outer edge of the field. Please also refer to
Close the metering slider that points to the edge of the field.
Fold the limited border spreading unit downwards.
Fold the limited border spreading unit up again before starting the two-sided
spreading.
8.7.3
Limited or full border spreading with the limited border spreading unit TELIMAT T1
(optional equipment)
The limited border spreading unit
TELIMAT T1
limits the spreading width from the
first tramline (1/2 working width from the edge of the field). See also
8.8
Spreading small strips of field
Adjust the spreading vanes on both spreading discs to the full border spread-
ing position in the fertiliser chart.
Содержание MDS 8.2
