Rauch MDS 8.2, Инструкция по эксплуатации

Страница: 66 / 146

Machine settings 8
60
8.2 Setting the application rate
8.2.1 Versions K/R/D/C
In versions K/R/D/C, the application rate is set via the stopper on the adjusting
segment. With the metering slides closed, the operator moves the stopper to the
position specified beforehand in the fertiliser chart or from a calibration test.
Procedure for adjusting the application rate
The following steps must be carried out on both sides of the machine.
1. Close the metering slide.
2. Close setscrew [2] at the stopper [4].
3. Determine the position for the scale setting in the fertiliser chart or based on
the calibration test.
4. Put the stopper into the corresponding position.
5. Tighten the setscrew again at the stopper.
n
WARNING
Risk of injury from rotating spreading discs!
The distribution unit (spreading disc, vanes) may catch and pull-in
body parts or objects. Contact with the distribution unit may injure,
crush or cut off body parts.
 Maximum admissible mounting heights at front (V) and rear
(H) are to be complied with at all times.
 Ensure that nobody is present in the hazard zone of the
machine.
 Never remove deflectors mounted on the hopper.