Rauch MDS 8.2, Инструкция по эксплуатации

Страница: 120 / 146

Maintenance and service 12
114
12.4 Cleaning
We recommend cleaning the machine with a soft jet of water immediately after
every use in order to maintain its value.
To facilitate cleaning, the protective grid in the hopper can be folded up (see
chapter
12.3: Opening the protective grid in the hopper, page 112 ).
In particular, the following instructions must be observed when cleaning:

Clean the outlets and the area of the slide guide from below only.

Only clean oiled machines at washing points fitted with an oil separator.

When cleaning with high-pressure water, never aim the jet directly at warning
signs, electrical equipment, hydraulic components, and sliding bearings.
After cleaning, we recommend treating the dry machine , especially the coated
spreading vanes and stainless steel parts , with an environmentally friendly
anti-corrosion agent.
A suitable polishing kit can be ordered from authorised dealers for use in treating
rust spots.
12.5 Adjusting the metering slide
Check that the metering slides open smoothly before every working season and
during the season, if necessary.
When spreading
seeds or slug pellets , it is recommended to check the metering
slide separately to ensure it opens evenly.
n
WARNING
Danger of crushing and shearing due to components operat-
ed by an external force
When working on power-operated components (adjusting lever,
metering slides), there is a crushing and shearing risk.
Pay attention to the shear point of the metering slide opening and
the metering slide during all adjustment work.
 Switch the tractor motor off.
 Remove the ignition key.
 Disconnect the power supply between the tractor and the
machine.
 Never actuate the hydraulic metering slide during adjust-
ment work.