Rauch AXIS H 30.2 EMC, Инструкция по эксплуатации

Страница: 110 / 132

Maintenance and repair 9
104
9.7 Checking the position of the spreading disc hub
The spreading disc hub must be centred exactly under the agitator.
Figure 9.7: Checking the position of the spreading disc hub
Requirements:

The spreading discs are removed (see “Dismounting spreading discs” sub-
section).
Testing the centring:
1.
Use suitable equipment to check that the spreading disc hub and agitator are
centred (e.g. straight edge ruler, protractor)

The axes of the spreading disc hub and of the agitator must be aligned.
They may deviate from each other by a maximum of
2 mm .
If this tolerance is exceeded, please contact your dealer or authorised specialist
workshop.
Checking the distance:
2.
Measure the gap between the upper edge of the spreading disc hub and the
lower edge of the agitator.
 The distance must amount to 136.5 mm (admissible tolerance ± 2 mm).
If this tolerance is exceeded, please contact your dealer or authorised specialist
workshop.
136,5
_ + 2 mm
< 2 mm