Rauch AXIS H 30.2 EMC, Инструкция по эксплуатации

Страница: 98 / 132

Spreading operation 8
92
8.12 Discharging residual material
To maintain the value of your machine, discharge the hopper immediately after
every use.
Instructions for completely discharging the residual material:
Small quantities of spreading material may remain in the mineral fertiliser spread-
er when discharging residual material normally. If you wish to discharge the re-
sidual material completely (e.g. at the end of the spreading season, when
changing spreading material), please proceed as follows:
1. Empty the hopper until no more spreading material is discharged (normal
discharge of residual material).
2. Switch off the tractor engine and the machine control unit and secure them to
prevent unauthorised starting. Remove the ignition key of the tractor.
3. Remaining fertiliser can be removed during machine cleaning with a soft wa-
ter jet;
See also “Machine cleaning“ on page -101 .
n
WARNING
Risk of injury due to rotating machine components
Rotating machine components (universal drive shaft, hubs) may
catch and pull-in body parts or objects. Contact with rotating
machine components may cause bruises, abrasions and crushing
injuries.
 Always stay outside the area of rotating hubs while the
machine is running.
 When the drive shaft is rotating, the metering slides are to
be operated from the tractor seat
at all times .
 Ensure that nobody is present in the hazard zone of the
machine.
NOTICE
If the machine is connected to an electronic control unit, a message is displayed
indicating that the drop point is temporarily set to 0 during discharge of residual
material.
Please observe the operator's manual of the electronic control unit.