Rauch AXIS H 30.2 EMC, Инструкция по эксплуатации

Страница: 118 / 132

Maintenance and repair 9
112

If the mark is not aligned to the string, the drop point must be readjusted.
n
WARNING
Danger of crushing and shearing due to components operat-
ed by an external force
When working on power-operated components (adjusting lever,
metering slides), there is a crushing and shearing risk.
Pay attention to the shear point of the metering slide opening and
the metering slide during all adjustment work.
 Switch the tractor motor off.
 Remove the ignition key.
 Disconnect the power supply between the tractor and the
machine.
 Never actuate the hydraulic metering slide during adjust-
ment work.
1. Attach a suitably thin string
at the rear in the direction of
travel (as shown) to the low-
er sides of the left and right
adjustment centres and taut-
en it.
Figure 9.17: Attaching the string to the ad-
justment centre
2. The triangular mark on the
adjustment centre must co-
incide with the tensioned
string.
Figure 9.18: Markings on the adjustment
centre
NOTICE
For adjustment of the drop point settings, please contact your dealer or an au-
thorised specialist workshop.