Rauch AXIS H 30.2 EMC, Инструкция по эксплуатации

Страница: 122 / 132

Maintenance and repair 9
116
Proceed as follows:
1.
Loosen the hose fitting at the end of the hydraulic hose to be replaced.
2. Discharge the oil from the hydraulic hose.
3. Loosen the other end of the hydraulic hose.
4. Immediately discharge the loosened hose end into the oil collecting vessel
and close the connection.
5. Release hose clamps and disconnect the hydraulic hose.
6. Connect the new hydraulic hose. Tighten the hose fittings.
7. Secure the hydraulic hose with the hose clamps.
8. Check the position of the new hydraulic hose.

The hose guide must be identical with the one of the old hydraulic hose.

There must be no abrasion points.

Do not twist the hose or route it under tension.
 The hydraulic hoses are now successfully replaced.
9.12.3 Checking hydraulic motors

Regularly check all hydraulic motors and at least before every spreading op-
eration.
The hydraulic motors are applied to drive the spreading discs. They are located
on the left and right under the protective cover of the transmission.
Figure 9.19: Hydraulic motor
[1] Hydraulic motor
[2] Transmission

Check the components for external damages and leaks.
1
2