Rational SCC Series, Руководство по обучению

Страница: 94 / 200

94
SCC
Edition 10-2008a
Error code SCC
Service 10
SC - Pump
Maintenance needed
- Appears for 30 sec. after switch ON
- Display can be cancelled by touch
- SC-automatic didn‘t work, water level does not decrease
- Check SC-pump and drain hose of steam generator
- Appears for 30 sec. after switch ON
- Display can be cancelled by touch
- Water level o. k., - Level electrode is working
- Too many pulses measured by CDS sensor
- Check electrode or water leakage through check valve
- Appears for 30 sec. after switch ON
- Display can be cancelled by touch
- Level electrode o.k.
- Check CDS sensor for blockage (no signal), water pressure too
low
As of software version 01-07-09
- Only hot air possible
- No low water signal during last 3x5 minutes of steam production
==> lled by auxilliary mode
- Check 0-1 signal from level electrode to pcb
- Appears for 30 sec. after switch ON
- Display can be cancelled by touch
- Level electrode no water sensing
- CDS sensor measured enough pulses;
- Possible reasons: water conductivity too low, osmosis water
treatment
Not activated
- Appears for 30 sec. after switch ON
- Only active with pcb-SW version 01-07-09 and eeprom version
later than 01-07-09 01-07-09
(Data protection Eeprom)
- Only active with pcb-SW version 01-07-09
- Data on EEPROM faulty
- New original eeprom needed
Not activated
Not activated
Service 11
CDS Sensor
Maintenance needed
Service 12
CDS Sensor without Signal
Maintenance needed
Service 13
Maintenance needed
Only hot air manual possible
Service 14
Maintenance needed
Only hot air manual possible
Service 15
Service 16
Unit without function
Service 17
EEPROM not initialized
Unit without function
Service 18
Service 19