Virtual Wall
Before using the virtual wall, install the batteries as shown in figure 3, open the bottom cover of
the virtual wall, install 2 pcs A batteries (pay attention to the correct polarity). After the installation,
close the bottom cover and tighten the screws.
Select the distance selector of the virtual wall according to the actual requirements; pull the shift
switch to the top position to select the low level(0-4m), to the middle to select the medium level(4-7m)
and to the bottom to select the high level( above 7m) ; See figure 2. the lower level, the lower power
consumption and the longer working time of batteries, therefore, you should try to select a lower level
whenever possible.
Press the power button on the virtual wall, the indicator will flash, when the voltage is normal, the
indicator will twinkle at each longer interval, if the batteries are in low power, the indicator will flash
faster, indicating that the batteries should be replaced, to avoid wrong startup, you should press and
hold the switch for a comparatively longer time (about 3~5 seconds) when turning on the power.
The virtual wall takes effect with IR signals, therefore, its functional range is a sector of about15°
, when the power is turned on, you should place it at the entrance of the area that you don’t want the
cleaner to clean, the cleaner won’t enter such area then.
The virtual wall uses 2pcs A (1.5V)batteries, when batteries’ power is short, you should replace
them, Continue to use the batteries with extremely short power may corrode the virtual wall.
The virtual wall is an accessory , it sends some special IR signals to form a blocked area to
prevent the cleaner from entering unnecessary areas, it is so named “virtual wall” because this
function acts like a wall.
01.
01.
02.
03.
04.
05.
Distance selector
IR guidance signal emitter
Wall signal emitter
indicator
Power switch
Rubber pad
Bottom cover
0-4m
4-7m
Over 7m
Figure 1
Figure 2
Figure 3
Figure 4
1.You need to use a screwdriver to open
the bottom cover of the virtual wall (see
Figure 3)
2.Please refer to figure 4 for the installa-
tion of batteries to avoid wrong polarity
that may damage the virtual wall.
1. Take out the battery before disposing of the cleaner.
2. Always remember to cut off the power before removing the battery.
3. Recycle or dispose of the battery properly.
4. To avoid explosion, never throw it into fire!
