04. The robot will enter the standby status when the power supply is cut off during the charging
process.
05. While the robot is being recharged on the station, if the preset time is reached, the robot will draw
back from the station and turn around to walk 1m ahead, and then it will enter the AUTO mode for
working.
06. By pressing the “Full-Go” button on the charging dock station, when the cleaner has been fully
charged on the dock station, it will draw back from the dock station and turn around to walk 1m
ahead, and then it will enter the AUTO mode for working.
07. While the robot is searching the station for recharge, if the battery power is lower than 8% of the
capacity, the robot will stop searching and enter the parking mode in a clear and bright place, and
it will sounds a “Toot” every 30 seconds.
08. During the charging process, the digital display will show the time of charging, 10 times of the
displayed value equals to the actual time of charging (min.)
The working time of the robot will also be shown during the cleaning process,
but the value displayed is the actual time of working (min.).
How to use the Charging dock station:
There are 5 buttons as shown in the figure below, including: power switch “ ”, Full-go button “ ”,
Clock button “ ”, timing button “ ” adjusting button “ ”
Connect the power socket on the dock station with external power supply, and then press the power
button “ ” to start the charging station (power on), the base will enter the LCD detection status and
show all content of the LCD as shown in the figure below:
The auto charging dock station have no the memory function ; if it’s
power off , all setting will be Cancelled and return to the default
During the process a setting, the power switch have the function of
“cancel” and the Full-go button have the function of “confirm”.
