9
for further information consult our website
www.raleigh.co.uk •
for video support & download
1 Identify left and right pedals
by the letter R & L stamped on
the end of the thread.
2 Identify left and right cranks.
Tighten pedal by hand into the
correct crank. Note the correct
rotation.
3 Tighten the pedals by hand, then
using a spanner fully tighten in
the correct rotation.
Remember
• Correct pedal and crank
• Correct tightening rotation
• Do not cross-thread
• Always keep pedals tight
• Check and retighten regularly
PEDALs
REFLECtoRs
For safety reasons it is very important that these are fitted correctly as the photograph
below. Depending on the type supplied, the front reflector may be fitted to the
handlebar or fork and the rear fitted to the seat post or rear bridge (see photos below).
Before you ride check the following:
1 Tyres are inflated to the recommended pressure.
2 Brakes are functioning properly.
3 Axle nuts or quick release levers are tightened.
4 Handlebar bolt(s) is tightened.
5 Seat bolt is tightened.
KEEp yOuR REFLEcTORs cLEAN -
cycLIsTs MusT BE sEEN .
THE REFLEcTORs FITTED TO yOuR NEW BIKE ARE A LEGAL REQuIREMENT,
suppLIED FOR yOuR sAFETy. DON’T BE TEMpTED TO REMOVE THEM.
Important: Be safe!
Ensure pedal is tight up against
the crank when fully tightened
