7
for further information consult our website
www.raleigh.co.uk •
for video support & download
1 Remove the plastic cap (if present)
from the top of the handlebar stem
cap and loosen the bolt using the
6mm allen key.
2 Turn the handlebar and set at
90 degrees to the front wheel.
Set at the required height and
re-tighten the bolt.
Important: Do not position the
stem outside the limit mark.
AttAChing thE hAnDLEbARs
1 Using an allen key, loosen the
2 side bolts (A) and turn the
handlebar through 90 degrees.
2 Adjust the tension of the headset by
turning bolt B if necessary but first
release the side bolts, adjust then
re-tighten. See page 15.
1 Loosen top nut, turn the handlebar
and set at 90 degrees to the front
wheel.
2 Re-tighten the nut fully so there
is no movement.
There are two types of handlebar attachment in general use, the quill stem type (single bolt) and the
threadless or A-Head type (two bolts). In addition, some BMX bikes have a different arrangement.
Stem Type (Single Bolt)
Threadless Type (3 Bolts) BMX Type
To adjust the saddle height, loosen the
clamp bolt using an Allen key, spanner
or the quick release lever and adjust the
seat post to the required height. Adjust
the height of the saddle so that when
cycling along, your leg will be slightly
bent with the pedal at its lowest point.
Important:
When altering the
height of the saddle,
you must not pull
the seat post out
further than the
limit mark.
sADDLE
ADjUstmEnt
A
B
