ToxiRAE Pro User’s Guide
12
Follow this procedure to charge the ToxiRAE Pro (the procedure is applicable to the
instrument with or without the rubber boot installed):
1. Plug the AC/DC adapter into the ToxiRAE Pro’s cradle.
2. Plug the AC/DC adapter into the wall outlet.
3. Place the ToxiRAE Pro into the cradle and press down until it is locked in place.
The ToxiRAE Pro begins charging automatically. The LED in the cradle should glow red
to indicate charging. When charging is complete, the LED in the cradle glows green.
WARNING!
To reduce the risk of ignition of hazardous atmospheres, recharge the instrument
only in areas known to be non-hazardous
.
Remove and replace batteries only in
areas known to be non-hazardous.
6.1. Removing The ToxiRAE Pro From The Charging
Cradle
To remove the ToxiRAE Pro from its charging cradle, press down on the latch release on
the back of the charging cradle while slightly tilting the ToxiRAE Pro toward the front of
the cradle, and lift it out.
6.2. Low Voltage Shutoff
When the battery’s charge falls below the shutoff voltage, the ToxiRAE Pro then turns
itself off. Recharge the battery by placing the ToxiRAE Pro in its cradle (the cradle
should be connected to the AC adapter).
Press on latch
Lift ToxiRAE Pro out of
charging cradle
