ToxiRAE Pro User’s Guide
36
2.
When you have completed your selection, press [MODE] repeatedly until “OK” is
highlighted.
3.
Press [Y/+] to save your selection, and exit the LCD Contrast
.
Note:
If you do not want to save the change, press [MODE] repeatedly until
“Cancel” is highlighted. Press [Y/+] to exit without saving the changes.
Exit (Monitor Setup Submenu)
Press [Y/+] to exit. Monitor Setup is exited. Exit (to exit Programming Mode) is
highlighted.
12.6. Exit (Exit Programming Mode)
To exit Programming Mode and return to normal operation, press [MODE] until the Exit
icon is highlighted. Press [Y/+] to exit. You will see “Updating Settings…” as changes
are registered and the mode changes to normal operation.
13. Policy Enforcement
The ToxiRAE Pro can be configured to enforce a facility/company’s requirements that
calibration and/or bump testing be performed at specified intervals, and to warn the user
that calibration/bump testing is required. In addition, it can require calibration or bump
testing and not allow normal operation of the instrument unless calibration or bump
testing is performed.
If Policy Enforcement is enabled and if the instrument has been bump tested and
calibrated in compliance with the policy settings, a check-mark icon is included along the
top of the ToxiRAE Pro screen:
If Policy Enforcement is enabled, then after startup the ToxiRAE Pro displays a screen
that informs the user that the instrument requires either a bump test or a calibration. If
both are required, then they are shown in sequence.
13.1. Setting Policy Enforcement
You must use ProRAE Studio II to make changes to Policy Enforcement settings. The
procedure differs, depending on whether you are using an AutoRAE 2 Cradle, a
ToxiRAE Pro Travel Charger, or a ToxiRAE Pro Desktop Cradle.
13.1.1. AutoRAE 2 Cradle
Note:
This procedure only works with a single AutoRAE 2 Cradle. It will not work with
an AutoRAE 2 Controller.
