MeshGuard User’s Guide
36
•
Press [MODE] and [Y/+] together for three seconds to exit
Diagnostic Mode and enter Detection Mode.
6.3.5 Zero Raw Count
Zero Raw Count is indicated by “0rC” followed by a number.
•
Press [N/-] to advance to the next reading.
•
Press [MODE] and [Y/+] together for three seconds to exit
Diagnostic Mode and enter Detection Mode.
6.3.6 Calibration Delta Counts
Calibration Delta CTS is indicated by “CdC” followed by a number.
•
Press [N/-] to return to the first raw count.
•
Press [MODE] and [Y/+] together for three seconds to exit
Diagnostic Mode and enter Detection Mode.
6.4 Diagnostic Mode Programming
You can enter a special programming mode from Diagnostic Mode in
order to perform advanced programming functions. These include:
•
Change Pan ID
•
Join a Mesh Network
•
Enable RFD or FFD
•
Return MeshGuard to original factory settings
•
Enable/disable audible and visible alarms
•
Select the sensor type
Note:
When the MeshGuard is in this programming mode, if you do not
make a change or press a key for 60 seconds, it reverts to the standard
Diagnostic Mode.
Important!
After you make changes in Diagnostic Mode, it is
recommended that you turn off the MeshGuard and turn it on again
before using it.
