MeshGuard User’s Guide
6 Diagnostic Mode
Diagnostic Mode provides raw data from sensors and about settings.
6.1 Entering Diagnostic Mode
Note:
To enter Diagnostic Mode, you must begin with the MeshGuard
turned off.
Press and hold [Y/+] and [MODE] until the MeshGuard starts.
The instrument goes through a brief startup, and then displays “dIA” to
indicate it is in Diagnostic Mode. It then switches to showing raw data
for the sensor (the display shows “rAU” followed by a number).
The following chart shows how to navigate Diagnostic Mode (pressing
N/- repeatedly steps through the screens):
34
