MeshGuard User’s Guide
4 Operating The MeshGuard
Make sure the battery is installed before operating the MeshGuard. Refer
to page 39 for information on battery installation and replacement.
4.1 Turning The MeshGuard On
Hold down the [MODE] key and release it when the MeshGuard beeps.
The monitor is now on, as indicated by the display:
The MeshGuard performs a self-test, followed by warm-up and zero
calibration. The display briefly shows the firmware version (for example,
“F1.0” means firmware version 1.0, “F2.0” means firmware version 2.0,
etc.):
Then the MeshGuard initializes the wireless network and displays this
information:
Note: If MeshGuard is unable to find a radio network to connect with, it
searches, and the display alternates between “rdo” and “Srh” (for “radio
search”).
10
