APPENDIX B
B-2
discourages the use of alkaline batteries with the
AreaRAE-Gamma’s if attempting communication with the
host. For optimal performance use the rechargeable
Lithium Ion batteries (part # 029-3051-000).
NOTE: ProRAE Remote Version 1.41 can support all firmware
versions, however some newer firmware versions are not compatible
with ProRAE Remote Version 1.0 or 1.20.
3.
MODE OF OPERATION:
The AreaRAE-Gamma must be
in regular operation mode. An antenna symbol should
appear on the AreaRAE-Gamma LCD indicating the host is
attempting to pull information from the unit. If any of the
programming sub-menus have been entered, such as
“Calibrate Monitor” then communication will fail.
4.
RADIO
: The ‘Radio’ button on all sensing AreaRAE-
Gamma’s must be activated. If pushing the ‘Radio’ button
does not make the red LED appear, then please contact
RAE Service at [email protected].
5.
COM PORT:
The same communication port that the
RS232 cable is plugged into must be selected in the
software. Within the ProRAE Remote proceed to ‘Set Up’
(A)>>’Host’>>’RF Modem Port’ (B) (Figure 2, Page 2).
Refer to TN-170 for more detailed setup instructions
including using USB ports. The chosen communication
port must be functioning properly and cannot be occupied
by another program. To verify the functionality of the
communication port, RAE Systems Com Port Checker Kit
(part #029-0005-000) can be used. Simply follow the
instructions provided with the Checker Program.
6.
NETWORK ID
: In order for the sensing units to be able to
communicate with the host controller, all components must
be setup with the same Network ID. Refer to TN-164 for
more information on the Network ID. If there are any
doubts about the Network ID or the need to change the
Network ID arises, then please contact RAE Systems
Service at 888-723-4800. By providing the serial number
of the Raelink modem or AreaRAE-Gamma units, the
Network ID can be verified.
