Figure 5-11
RAS Port Configuration
Step 2
Select the icon in the Review column.
Step 3
Enter the port value in the H323 RAS port number field.
Step 4
Select Apply.
Step 5
Select Close.
Configuring the UDP Port for the Gatekeeper on the Scopia Elite MCU
The Scopia Elite 6000 Series MCU has designated port 1719 for gatekeeper use. You can
configure a different port to enable communication with the gatekeeper (for example, if port
1719 is busy). Port 1719 is also used for RAS (to configure the UDP port for RAS, see
“Configuring the UDP Port for RAS on the Scopia Elite MCU” on page 40
).
Note
If you close port 1719, you must configure another port for both the gatekeeper and RAS. If
you configure a different port for the gatekeeper, you do not need to configure a different
port for RAS.
Procedure
Step 1
Navigate to the MCU H.323 Protocol section by selecting Configuration > Protocols.
Step 2
Locate the Enable H.323 protocol section (see
).
Figure 5-12
H.323 Protocol section of the Protocols tab
Step 3
Enter the port value in the Gatekeeper port field.
Step 4
Select Apply.
RADVISION | Installation Guide for Scopia Elite 6000 Series MCU Version 8.0
Performing the MCU Initial Configuration | 41
