RADVision MCU-323, Руководство пользователя

Страница: 153 / 185

10-1
LED Indications
The Power LED does not light
This indicates that the MCU-323 is not properly connected to the power source. Make sure
the power cable is firmly connected to the MCU-323 and to the power outlet.
The Link LED of a connected LAN port does not light
This indicates that the LAN port is not connected to the network segment. Make sure that
the connections are secure, that you are using the correct Ethernet cable and connector, and
that the devices at both ends of the Link are powered-up.
Initial Setup Problems
!
When entering an MCU-323 IP address manually, the address must have a full three
digit component for each part of the IP address (for example, 192.003.045.012).
!
Check the password — passwords for the MCU-323 are case sensitive.
Console Port Access Problems
You can access the MCU-323 through the console port for local configuration and
diagnostics.
"
Access problems from a local terminal connected to the MCU-323 console port
!
Make sure the MCU-323 is connected to the terminal using a crossed RS-232 cable.
!
Check that the connections are secure at both ends.
!
Verify communication with the terminal.
"
To verify the communication between the MCU-323 and a terminal
1. Run the terminal emulation application (e.g. HyperTerminal). The command prompt is
displayed.
2. Verify that the communication settings for the terminal are as follows:
9600 Baud rate, 8 data bits, no parity, 1 stop bit, no Flow Control.
3. Check to see that the crossed cable is properly connected at both ends.
4. Click Enter. The command prompt (cursor) moves down to the next line to indicate
that the connection is active.