The
Status
menu provides basic information about local and remote station. Information is valid the
moment the page is open, or the Refresh button is hit.
The
Status – Brief
tab shows only the most important values whereas the
Status – Detailed
tab
provides further details. Below is a list of all values - according to the tab
Status – Detailed
.
The
icon marks fields which are automatically updated when periodical refresh is enabled by
pressing the
Start
button.
7.3.1. Status - General
Unit type indicator.
Unit code
Unit serial number.
Serial no.
Station name assigned by user.
Station name
Station location assigned by user.
Station location
Unit’s firmware version.
Firmware version
The internal real-time clock. The clock is set manually or it is synchronized
with NTP server and set for both units.
Date, Time
Temperature inside the unit (on the modem board).
Inside temperature [°C]
Unit’s power supply voltage level.
Voltage [V]
The power supply input the unit is powered from.
PoE - unit is powered via Ethernet cable plugged into port "E1+POE".
AUX - unit is powered via DC cable plugged into port "P".
Power supply
7.3.2. Status - Radio
Radio unit type: L (Lower) or U (Upper) part of the frequency band.
Radio type
Horizontal or vertical polarization based on the physical installation. Indic-
ates the polarization of the received signal. Local and Peer are indicated
separately. The proper position of the cable is sideways down.
Notice for the RAy2-17 and RAy2-24 units: One side of the link must be
installed in vertical polarization and the other in horizontal polarization.
Polarization
Displays the currently selected frequency table.
Frequency table
Current transfer capacity of radio channel for user data.
Net bitrate [Mbps]
The maximum RF channel capacity according to installed feature key.
Max. net bitrate [Mbps]
One of the standard channel widths can be selected. This parameter must
be set identically in local and remote.
Bandwidth [MHz]
Used channels. Both number of the channel and frequency in GHz are
listed.
TX and RX channel [GHz]
Modulation type currently used for transmitting. When adaptive modulation
is enabled, the ACM letters are displayed as well as information about
TX modulation
maximum permitted modulation: “current modulation ACM / maximum
modulation”
Current output power on the RF channel in dBm. If ATPC is enabled, the
ATPC letters are displayed as well as information about maximum permitted
power: “current power ATPC / maximum power”
TX power [dBm]
65
© RACOM s.r.o. – RAy2 Microwave Link
Configuration
Содержание Ray2
