RACOM Ray2, Руководство пользователя

Страница: 66 / 235

Received signal strength. If ATPC is enabled, the ATPC letters are dis-
played as well as information about threshold value for activation of power
control loop: “current RSS ATPC / threshold RSS” RSS [dBm]
Signal to Noise Ratio. If ATPC is enabled, the ATPC letters are displayed
as well as information about threshold value for activation of power control
loop: “current SNR ATPC / threshold SNR” SNR [dB]
Bit Error Rate is registered at the receiving end; instantaneous value. BER [-]
Time elapsed since the current link connection has been established. Link uptime
7.3.3. Status - Switch interface
Egress rate limit Air
Status of the Egress rate limitter on the Air interface.
Message format: "xx.xx Mbps Ly auto" where:
Egress speed limit. xx.xx Mbps
L1/L2/L3 which Ethernet layer is used for speed calculation. Ly
gives information about active Speed guard function. auto
Status of ethernet interface. Current bit rate (10 = 10BASE-T, 100 =
100BASE-TX and 1000 = 1000BASE-T) and state of duplex (FD = full du-
plex, HD = half duplex). Link mode Eth1, 2
7.3.4. Status - Service access
HW address of the ethernet module. MAC address
IP address in the standard dotted decimal notation, including the bit width
of netmask after the forward slash. IPv4 address
Service access via VLAN management only. Management VLAN
Services enabled for unit management and monitoring (Web, Telnet, SSH,
SNMP, NTP). Services
7.3.5. Status - Radio link statistics
Time of log clearing. Statistics Cleared
Period of log refresh. Statistics Period
Overall time the link has been connected. Overall Link Uptime
Overall time the link has been disconnected. Overall Link Downtime
The ratio of Uptime and Downtime .
Reliability [%]
Current time the link has been connected. Current Link Uptime
The longest downtime period recorded. The Longest Drop
Length of the last link interruption. The Last Drop
Number of link interruptions. Number of Drops
RAy2 Microwave Link – © RACOM s.r.o. 66
Configuration