RACOM Ray2, Руководство пользователя

Страница: 86 / 235

7.5.2. Interface
Port
Port settings
Fig. 7.18: Menu Switch settings - Port
Phyter is responsible for Ethernet signal conversion between wire (e.g. CAT7 cable) and internal switch
bus.
Port name
Identification of the internal switch port. The switch ports are connected to an ex-
ternal port or to an internal device (radio modem, management CPU).
The external port (with RJ45 interface) labeled "E1+POE".
The external port (with SFP interface) labeled "E2". Eth1
Eth2
Link status
Ethernet link status can be
no link signal detected down / type
link signal is detected up / type
The type of the physical layer is indicated after the slash
metallic Ethernet interface copper
fibre Ethernet interface fibre
Speed / duplex
Ethernet link Speed and duplex.
10/100/1000 Mbps Speed
full/half Duplex
SFP info
Information about the (optionally) inserted SFP module. The three different types
of SFP modules can be used:
dual mode with LC connector Fibre
single mode with LC connector Fibre
RAy2 Microwave Link – © RACOM s.r.o. 86
Configuration