RACOM Ray2, Руководство пользователя

Страница: 126 / 235

It is possible to make a temporary backup of the unit configuration. The backup is
stored directly in the unit FLASH memory. Settings -
Internal backup
(Local)
NOTE: The internal backup is deleted if factory settings or
firmware upgrade are performed.
L P
o
L
o
S
U
Make a temporary backup of the unit configuration locally in
the unit FLASH memory. Internal backup
Restore (from the unit FLASH memory) the temporary backup
of the unit configuration. Internal restore
The local temporary backup of the unit configuration can be
restored using the hardware button. The HW button is located
next to the DC connector within the port marked "P".
The rollback and reboot functions are suppressed while
restoring from internal backup. All changes are applied imme- Internal restore
- HW button
diately. Should the time zone be changed, the unit has to be
restarted for changes to take effect.
Press the HW button for the required time interval of 5
seconds. The button being pressed is confirmed by the Status
LED flashing green. After the 5 seconds guard time, the unit
restores to customer settings.
Saving and restoring user accounts. Users (Local)
Backup local unit user accounts to an external file. The file
is downloaded to management PC.
NOTE: The "super" user privileges are necessary to be able
to perform this action. Backup
to external file
L P
L
S
o
U
Restoring user accounts from an external backup file. Upload file
& restore
Applying default values to configuration parameters. Default settings
Whole set of parameters from the Link settings menu tree is
affected.
Restore link
settings
(Local & Peer)
L P
o o
L
S
U
Whole set of parameters from the Switch settings menu tree
is affected.
Restore switch
settings (Local)
L P
L
o
S
U
WARNING: Using the factory settings function will revert the
unit to its original state. All configuration items, user accounts, Factory setting
(Local)
measured values and system messages (logs) will be irre-
versibly deleted.
WARNING: This task takes a few minutes to complete. Do
not interrupt the power supply during the operation.
L P
o
L
o
S
o
U
Applying Factory settings to Local unit. The unit reboots itself
after applying all changes. Restore
factory settings
It is possible to bring the unit to Factory settings by holding
the hardware button depressed during unit's boot. The HW Restore
factory settings
- HW button
RAy2 Microwave Link – © RACOM s.r.o. 126
Configuration