ANTM3 VELLEMAN
1
ANTM3 – Compact indoor UHF, VHF and FM antenna with amplifier
1. Introduction & Features
Thank you for buying the
ANTM3
! Please read the manual carefully before bringing this device
into service.
This indoor amplifying system for TV antennas features two rotating telescopic antennas, a flat
antenna and an amplifier. Thanks to its dimensions, this is the ideal device to be fitted on your
TV set. The
ANTM3
effectively reduces the amount of “snow” on your screen and provides a
clearer image. The device can be used on the VHF (frequency 1-12), UHF (frequency 13-68)
and FM (88-108 MHz) bands.
Make sure that the device was not damaged in transit. If the device is damaged, you should
contact your dealer and postpone installation of this device.
2. Safety Instructions
•
A qualified technician should install and service this device.
•
Damage caused by disregarding certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for the ensuing defects or problems.
•
Do not switch the device on immediately if it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room
temperature.
•
Make sure that the available voltage does not exceed the voltage stated in the specifications
of this manual.
•
Do not crimp the power cord and protect it against damage from sharp edges. Ask an
authorised dealer to replace the cord if necessary.
•
Always disconnect the device from the mains when it is not in use or when you wish to clean
it. Only handle the power cord by the plug. Never pull out the plug by tugging the power cord.
•
Note that damage caused by user modifications to the device is not covered by the warranty.
Keep the device away from children and unauthorised users.
3. General Guidelines
•
This device should only be operated with an alternating current of max. 230Vac/50Hz and is
designed for indoor use only.
•
Do not shake the device. Avoid brute force when installing or operating the device.
•
Select a location where the device will be protected against extreme heat, moisture and dust.
•
Do not use the device if the ambient temperature exceeds 45°C.
Protect this device against rain and moisture
Unplug the supply cable before you open the housing
Be very careful when installing the device : touching
live wires can cause life-threatening electroshocks.
