RACOM Ray2, Руководство пользователя

Страница: 37 / 235

Warning
During operation, never bring the waveguides of the stations close to each other. There is
a risk of damaging sensitive input circuits.
5.1. Service access
The RAy2 link is supplied with a default configuration of access parameters:
Unit L has the service IP address 192.168.169.169 and mask 255.255.255.0,
Unit U has the service IP address 192.168.169.170 and mask 255.255.255.0,
access is allowed over HTTP, HTTPS or SSH,
the username is
admin and the password is also admin .
On your PC setup an IP address that is within the mask, i.e. 192.168.169.180.
Then open the https configuration interface, e.g.
https://192.168.169.169
Other access options are described in the chapter Configuration - Link settings - Service access of this
manual.
When connection has been established, use the Service access menu to customise access parameters.
Default IP addresses should be replaced with well-chosen operating addresses. Leaving default ad-
dresses in place can lead to network problems later.
The menu contains parameters for the entire link, both for the Local and remote Peer units. If a connec-
tion has been established, both sets of parameters have been set. While working with an isolated unit,
only Local parameters are functional for the currently connected unit.
Note
If the link is OK and there are no parameters shown of the station Peer , it is necessary to
click on Refresh .
Follows the description of basic settings. After entering values on the screen always save the content
by clicking on
Apply .
Note
If there is any problem with https certificate after completing the firmware upgrade, please
see the Annex Https certificate for further steps.
37 © RACOM s.r.o. – RAy2 Microwave Link
Step-by-step Guide