RACOM Ray2, Руководство пользователя

Страница: 46 / 235

b. Slide the antenna bracket onto the mast tube and clamp to the mast by tightening the nuts.
Recommendation: Keep the gap between the two saddle plates (part No. 3) as wide as possible,
so the horizontal angle adjustement screw can fit in this gap. The range of horizontal adjustement
is consequently wider. This has a bigger effect when the mast diameter is smaller.
Fig. 6.10: Attaching the bracket to the mast tube Fig. 6.11: Bracket on the mast tube
c. Screw the hanging bolt (part No. 7) into the upper hole of the mounting plate so that the antenna
can be hung on the mounting plate holder. Hang the antenna on it and tighten the lower bolt. (part
No. 8)
Fig. 6.12: Hanging the bolt on the holder
Fig. 6.13: Correct position of the mounting plate
RAy2 Microwave Link – © RACOM s.r.o. 46
Installation