Quincy Compressor QCV 045, Инструкция

Страница: 33 / 56

Section VI - Operating instruction
33
 Initial start-up
 Starting
 During operation
 Stopping
 Taking out of operation
The operator must apply all relevant safety precautions. See
section Safety precautions during operation
Initial start-up
The pump is supplied with oil in the gearbox.
Initial start-up instructions:
 Remove the canopy panel(s) in order to get access to the internal components.
 Check the process lines for the correct size to prevent high pressure drop and for
cleanliness to protect the pump.
 Make sure the pump outlet is not obstructed.
 Check that the electrical connections correspond to the applicable codes and that all
wires are clamped tight to their terminals. The installation must be earthed and
protected against short circuits by fuses of the inert type in all phases.
 An isolating switch must be installed near the pump.
 Check the oil level. The minimum level should reach the oil sight glass when the pump
is stopped. If needed, top up the oil.
 Take care that no dirt drops into the oil system. Refit and tighten the filler plug.
 Provide labels, warning the operator that:
 The pump may automatically restart after voltage failure (if activated, consult Quincy).
 The pump is automatically controlled and may be restarted automatically.
 The pump may be remotely controlled.
 Switch on the voltage and switch it off immediately. Check the rotation direction of
drive motor while the motor is coasting to a stop. The correct rotation direction of the