Technical Guide: RDMS Telnet and Serial Control
38
Quasonix, Inc.
System Lock is active
2.1.1.10 Best Channel Selector
–
BCS
The BCS command displays and controls the best channel selector settings.
BCS [<e>]
- Enables best channel selection
where: <e> - Enable
0
–
Disabled (Off)
1
–
Enabled (On)
BCS [T <t>]
- Sets best channel selector threshold <t>, 0 to 255
BCS [PH <n>]
- Sets best channel selector pin hold delay 2^<n>, 0 to 15 cycles
BCS [S <s> <e>]
- Sets best channel selector source <s> enable to <e>
where:
<s> - Sources
CH0 - Channel 0
CH1 - Channel 1
INT - Internal
<e> - Enable
0 - Disabled
1
–
Enabled
Example:
PCMFM$bcs
BCS enabled
BCS threshold 192
BCS pin hold delay 2^2 cycles
System status display elements:
BCS - - Best channel selector
2.1.1.11 Bit Rate - BR
The Bit Rate command sets or reports the baseband bit rate. The value reported by this command is shown on the
Browser Interface in the Advanced Settings, Sync Bit Rate field.
BR [<r>|M|SM]
<r> - Set bit rate to <r>, 0.0240 to 23.0000 Mb/s
M - Show measured bit rate
SM - Set bit rate to measured bit rate
