26
Introduction
Figure 8
Installing Top X-Axis Gear Racks
j.
Use a 2.5 mm hex wrench to fully tighten the four screws that secure the Right Robot Loader
Bracket (you partially installed these earlier; see
Figure 9
).
k. Use a 2.5 mm hex wrench
to fully tighten the two screws in the Loader Bracket Adapter (partially
installed earlier; see
Figure 9
).
Install screws through the slots in the top rack supports and
up through the underside of the top X-axis gear racks.
Содержание Scalar i6000
Страница 14: ...14 Introduction Figure 1 Power Rail Position in Module Two bridge clamps connect adjacent rails...
Страница 15: ...Scalar i6000 Installation Guide Super Doc 15 Figure 2 Power Rail Front 4 pin and 3 pin connectors...
Страница 23: ...Scalar i6000 Installation Guide Super Doc 23 Figure 6 Installing Bottom and Middle Racks...
Страница 24: ...24 Introduction Figure 7 Middle X Axis Gear Rack...
